Align Trex450V2

Spec

• CCPM SERVO Hitec 5065MG
• TAIL SERVO Align 520
• GYRO Futaba 401
• ESC Phoenix-CC35
• BEC UBEC @ 6V
• MOTOR Zpower 3300Kv @ 14T
• Rx Spektrum AR6100e
• 3 cell 2200 Mah
• Collective Pitch + / - 12 degree
• Cyclic Pitch 8 degree
• AUW under 780g

ESC Castle Creation35A

Setting

1. Cutoff Voltage
   1. Auto-Lipo* / 9.0V Cytoff
2. Current Limiting
   3. Normal*
3. Brake Type
   5.Brake Disabled
4. Throttle Type
   2. Fixed Throttle
5. Electronic Timing Advance
   3. Standard Advance*
6. Low Voltage Cutoff Type
   2. Soft Cutoff
7. Soft Start
   2. Soft Cutoff
8. PWM Switching Rate
   1. 13kHz*

TROUBLESHOOTING

Problem: The LED comes on when I go to full throttle.

Solution: 1. RESET ESC

1. Enter Programming Mode1B. Connect battery power to the ESC . The ESC will beep its Initialization tones when first plugged in After 3 Seconds. The ESC will emit another short tone and the LED on the ESC should flash a short, single flash that repeats. If the ESC flashes continuously it is not seeing a full throttle position. Move your throttle trim to the position or increase your full throttle Endpoint or ATV on your TX.
2. This is normal. The LED comes on when full throttle has been reached. If the unit is in Auto-Calibrating Throttle mode (program setting 4-1) then you may see full throttle LED indication before the stick is in the full up position. Simply continue moving the stick to full. The controller will detect the stick travel & adjust full throttle accordingly. ( Adjust TX ATV High end point will be solve )

Z-power 3800Kv & 4000Kv
Bearing size 0.1250 x 0.3125 x 0.1406 ( 1/8 X 5/16 X 9/64)

SR2-5ZZ (KLN)

15 12 2007 SW

Nov 2007

2007 Stanley Prison